The short version of hGH fragment fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-08-30 and is reviewed periodically as new material appears.
Quality varies among research-grade suppliers, so certificates of analysis and independent testing are important for verification. A typical certificate reports purity by HPLC, identity by mass spectrometry, appearance, and sometimes residual solvents or water content. AOD9604 is often sold as a research chemical not intended for human consumption, and labels can be inaccurate. Common misconceptions include treating the peptide as a form of growth hormone, assuming supplement status, or expecting approved-drug quality from unregulated products.
AOD9604 is commonly supplied as a white to off-white lyophilized powder. The powder is typically stored at -20 °C or below, protected from light and moisture, because peptides can degrade through oxidation, hydrolysis, or aggregation. If it is reconstituted for laboratory use, an appropriate aqueous buffer or solvent is chosen, and the solution is kept cold and handled to avoid repeated freeze-thaw cycles. These practices support stability but do not imply suitability for human use.
AOD-9604 is prohibited in sport by the World Anti-Doping Agency under the peptide hormone class. Its presence in a sample can be detected through mass spectrometry-based methods, although the exact assay depends on the laboratory. In research settings, material is often supplied as a lyophilized powder for reconstitution. Buyers and researchers should note that products labeled AOD-9604 may vary in purity and actual peptide content. Analytical certificates and independent testing are common ways to verify identity, but no global harmonized standard exists for all commercial lots.
AOD-9604 is a synthetic peptide whose sequence is modeled on the C-terminal region of human growth hormone. Published descriptions commonly place it as a modified fragment corresponding to hGH amino acids 176–191, with a tyrosine residue added or retained at the N-terminus to support detection and handling. It is not intact growth hormone and lacks the full receptor-binding architecture of the parent protein. The molecule was developed as a research candidate for metabolic studies rather than as a replacement for growth hormone therapy. Its identity is defined by its amino acid sequence rather than by any single commercial preparation.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilized form; visual inspection |
| Solubility | Soluble in water and aqueous buffers | Depends on pH, purity, and counterion |
| Typical storage | -20 °C or below, desiccated | Protect from light; avoid repeated freeze-thaw after reconstitution |
| Common analytical method | Reversed-phase HPLC and mass spectrometry | Purity by HPLC; identity and mass by LC-MS or MALDI-TOF |
| Common synonyms | hGH fragment 176–191; AOD-9604 | Names vary in research and product labeling |
Stability of AOD-9604 depends on storage conditions. Lyophilized powder is generally more stable than reconstituted solution. Recommended storage is typically at -20°C or lower, protected from light and moisture. Repeated freeze-thaw cycles can cause aggregation or degradation. In solution, the peptide may be susceptible to hydrolysis or oxidation, so aliquoting and cold storage are common practices. Researchers often add stabilizers such as mannitol or trehalose during lyophilization to improve shelf life.
Quality control for AOD-9604 involves verifying identity, purity, and concentration. Suppliers may provide a certificate of analysis listing HPLC purity and mass spectrometry data. Independent verification is advised because peptide products can vary in quality. Researchers should check for counterions, residual solvents, and microbial contamination. Proper documentation supports reproducibility and safety in laboratory studies. When sourcing, institutions often require third-party testing and detailed chain-of-custody records. These steps help ensure that experimental results are attributable to the peptide rather than impurities.
Analytical characterization of AOD-9604 typically employs reversed-phase high-performance liquid chromatography (RP-HPLC) to assess purity and identity. Mass spectrometry provides confirmation of molecular mass, while amino acid analysis can verify composition. These methods are standard for peptide research chemicals. Because the peptide lacks a distinct chromophore, detection often relies on ultraviolet absorbance at 214 nm or mass spectrometric response. Laboratories may also use capillary electrophoresis for separation. For example, size-exclusion chromatography can detect aggregates.
Researchers have studied the fragment in cell and animal models to understand its metabolic actions. Some experiments report effects on fat breakdown and fat storage pathways, but the underlying mechanism remains incompletely defined. AOD-9604 does not appear to stimulate the same broad growth hormone receptor signaling as full-length hGH. Whether its observed activities arise from direct receptor interactions or downstream metabolic changes is an open question. Results from different assays are not always consistent.
AOD-9604 is a synthetic peptide modeled on the C-terminal region of human growth hormone. It corresponds to residues 176-191 of the 191-amino-acid hGH sequence. The fragment is not the full hormone and lacks the receptor-binding region associated with growth and metabolic effects of hGH. Researchers developed it to isolate a specific portion of hGH for study. Its exact sequence and length are often stated in peptide catalogs and patents.
Interest in AOD-9604 arose from attempts to separate metabolic effects from growth effects attributed to hGH. Early work explored whether the fragment could influence lipolysis or fat oxidation without promoting growth. Those questions remain partly unresolved because human data are limited and results have varied across studies. The peptide is not a hormone replacement for hGH and is not equivalent to hGH in clinical use. Its research history includes both laboratory studies and commercial marketing claims that are not the same as regulatory approval.
AOD-9604 is a synthetic peptide whose structure corresponds to a C-terminal segment of human growth hormone. It is often described as hGH fragment 176-191, a 16-amino-acid sequence. The peptide was designed to isolate a region of hGH associated with fat metabolism while avoiding the full hormone's growth-promoting actions. Laboratory and commercial materials typically present it as a lyophilized powder for research use. Its identity is defined by amino acid sequence, not by a single brand.
In the scientific literature, AOD-9604 appears in reviews of growth hormone fragments and in discussions of peptide-based metabolic research. Some sources distinguish it from growth hormone itself, while others group it with compounds marketed for weight management. The evidence base is small compared with approved obesity medications. Questions about long-term efficacy and clinical relevance remain open, and independent replication of key findings is limited. Most published reports are early-stage and exploratory.
AOD-9604 is a synthetic peptide modeled on the C-terminal region of human growth hormone. It is often described as hGH fragment 176-191. Research interest arose because it was designed to isolate possible effects on fat metabolism from other actions of growth hormone. It is not a full growth hormone molecule. Its development history includes early laboratory and animal studies followed by human trials. The peptide has been examined in laboratory, animal, and limited human studies.
The compound has been studied as a potential treatment for obesity and related metabolic conditions. Published trials have examined changes in body weight, fat mass, and safety markers over limited durations. Results have been mixed or modest, and no large-scale outcome trials are established. Regulatory agencies in several countries have not approved it as a therapeutic drug. Some commercial products have been marketed outside regulated pharmaceutical channels, which raises questions about quality and claims.
The formylglycine tag or aldehyde tag is a convenient 6- or 13-amino acids long tag fused to a protein of interest. The 6-mer tag represents the small core consensus sequence and the 13-mer tag the longer full motif. The experiments on the genetically encoded aldehyde tag by clearly showed the high conversion efficiency with only the core consensus sequence present. Four proteins were produced recombinantly in E.coli with an 86% efficiency of for the full-length motif and >90% efficiency for the 6-mer determined by mass spectrometry. The size of the sequence is analogous to the commonly used 6x His-Tag and has the advantage that it can also be genetically encoded. The sequence is recognized in the ER solely depending on primary sequence and subsequently targeted by FGE. Notably, in the setup of recombinant expression proteins in E. coli a coexpression of exogenous FGE aids full conversion, although E. coli has endogenous FGE-activity. The introduction of an aldehyde tag has a workflow that consists of three segments: A the expression of the fusion protein, that carries the peptide tag derived from the sulfatase motif, B the enzymatic conversion of Cys to f(Gly) and C the bioorthogonal probing with hydrazides or alkoxy amines (Fig. 1).
F-ATPase gene linkage and gene order are widely conserved across ancient prokaryote lineages, implying that this system already existed at a date before the last universal common ancestor, the LUCA. Nick Lane: The Vital Question: Energy, Evolution, and the Origins of Complex Life, Ww Norton, 2015-07-20, ISBN 978-0393088816 (Link points to Figure 10 showing model of ATP synthase) Boris A. Feniouk: "ATP synthase — a splendid molecular machine" Well illustrated ATP synthase lecture Archived 2008-12-02 at the Wayback Machine by Antony Crofts of the University of Illinois at Urbana–Champaign. Proton and Sodium translocating F-type, V-type and A-type ATPases in OPM database The Nobel Prize in Chemistry 1997 to Paul D. Boyer and John E. Walker for the enzymatic mechanism of synthesis of ATP; and to Jens C. Skou, for discovery of an ion-transporting enzyme, Na+, K+-ATPase. Harvard Multimedia Production Site — Videos – ATP synthesis animation David Goodsell: "ATP Synthase- Molecule of the Month" Archived 2015-09-05 at the Wayback Machine
The advantage in atom economy of using NCAs for peptide formation is that there is no need for a protecting group on the functional group reacted with the amino acid. For example, the Merrifield synthesis depends on the use of Boc and Bzl protecting groups, which need be removed after the reaction. In the case of Bailey peptide synthesis, the free peptide is directly obtained after the reaction. However, unwanted and difficult to remove by-products may be formed. An N-substitution of the NCA (for example, by an o-nitrophenylsulfenyl group) can simplify the subsequent purification process, but on the other hand deteriorates the atom economy of the reaction. The synthesis of NCAs can be carried out by the Leuchs reaction or by the reaction of N-(benzyloxycarbonyl)-amino acids with oxalyl chloride. In the latter case, again the procedure is less efficient in the sense of atom economy. The following peptides were synthesized using this method by 1949:
Annals of Clinical Biochemistry is a bimonthly peer-reviewed scientific journal covering all aspects of clinical biochemistry. The editor-in-chief is Michael J Murphy (University of Dundee). It was established 1960 and is published by SAGE Publications on behalf of The Association for Clinical Biochemistry and Laboratory Medicine. The journal is abstracted and indexed in: According to the Journal Citation Reports, its 2012 impact factor is 1.922, ranking it 12th out of 31 journals in the category "Medical Laboratory Technology". Official website
Aside from the 22 proteinogenic amino acids, many non-proteinogenic amino acids are known. These either are not found in proteins (for example carnitine, GABA, ornithine) or are not produced directly and in isolation by standard cellular machinery. For example, hydroxyproline is synthesized from proline, and selenomethionine is produced by metabolic modification of methionine. Non-proteinogenic amino acids that are found in proteins are formed by post-translational modification. Such modifications can also determine the localization of the protein, e.g., the addition of long hydrophobic groups can cause a protein to bind to a phospholipid membrane. Examples:
Sources: en.wikipedia.org
On-line mass spectrometry was develop to solve some of the limitations and problem that develop from off-line analysis, such as evaporation and chemical reactions of particles in the filters during long analysis time. On-line Mass spectrometry solves these problems through the collection and analysis of aerosol particles in real time. On-line instruments are very portable and allow for spatial variability to be examined. These portable instruments can be put on many different platforms such as boats, planes, and mobile platforms (e.g. car trailers). An example of this is in the picture at the beginning with the instrumentation attached to an aircraft. Like off-line, on-line mass spectrometry has many different type of instruments, which can be broken up into two types; instruments that measures the chemistry of the particle ensemble (bulk measurement) and those that measure the chemistry of individual particles (single-particle measurement). Thus based on analytical need different instrumentation is used in analysis of the aerosol particles.
The word "aptamer" is a neologism coined by Andrew D. Ellington and Jack Szostak in their first publication on the topic. They did not provide a precise definition, stating "We have termed these individual RNA sequences 'aptamers', from the Latin aptus, to fit." The word itself, however, derives from the Greek word ἅπτω, to connect or fit (as used by Homer (c. 8th century BC)) and μέρος, a component of something larger. A typical aptamer is a synthetically generated ligand exploiting the combinatorial diversity of DNA, RNA, XNA, or peptide to achieve strong, specific binding for a particular target molecule or family of target molecules. Aptamers are occasionally classified as "chemical antibodies" or "antibody mimics". However, most aptamers are small, with a molecular weight of 6-30 kDa, in contrast to the 150 kDa size of antibodies, and contain one binding site rather than the two matching antigen binding regions of a typical antibody.
An automated synthesis is very similar in procedure to performing a manual synthesis. The overseeing chemist decides on a target molecule then formulates the experimental plan, which is a sequential series of steps. Then, they collect the required equipment and execute the plan. The automated synthesis follows the same pathway, except that the computer devises and executes the experimental plan. However, human revision is usually still required to ensure the automated route is practical and there are no implicit steps or conditions missing from the proposed procedure. In organic synthesis, organic synthesis software is used to automate the process of identifying sequences of reactions or routes that can be used to synthesize organic compounds.
In the field of pharmacokinetics, the area under the curve (AUC) is the definite integral of the concentration of a drug in blood plasma as a function of time (this can be done using liquid chromatography–mass spectrometry). In practice, the drug concentration is measured at certain discrete points in time and the trapezoidal rule is used to estimate AUC. In pharmacology, the area under the plot of plasma concentration of a drug versus time after dosage (called "area under the curve" or AUC) gives insight into the extent of exposure to a drug and its clearance rate from the body.
Sources: en.wikipedia.org
Lyophilized AOD9604 is generally kept at -20 °C or colder, desiccated, and protected from light. Reconstituted solutions are usually refrigerated and handled to minimize repeated freeze-thaw cycles. These are general laboratory handling practices, not instructions for human use.
Mass spectrometry, such as LC-MS or MALDI-TOF, confirms the molecular mass and can reveal sequence-related impurities. Reversed-phase HPLC is used for purity, and peptide mapping or amino acid analysis can support sequence identity. No single method establishes every quality attribute.
No. AOD9604 is a short synthetic fragment of the hGH sequence, not the full 191-amino-acid hormone. It lacks the regions that mediate hGH receptor activation and growth-promoting effects. Products labeled as AOD9604 should not be assumed to have the same properties as hGH.
No. It is a synthetic peptide fragment modeled on part of human growth hormone, not the full hormone. It does not contain the complete sequence or receptor-binding regions of hGH.